K-303 50ml Transparent UV glue curing adhesive with 9/51LED UV flashlight for large- area glass crystal bonding, such as: glass mosaic, glass crafts, crystal crafts.
K-303 is dedicated to the adhesive acrylic (PMMA) or acrylic adhesive between the glass and metal between the high adhesive strength, e.g., acrylic billboards, adhesive acrylic products, but also for other transparent plastics such as PC, PVC, PS, ABS and other plastics adhesive fixing, bonding with excellent results, such as plastic boxes, plastic products, such as bonding.
Features:
- The above data are based on our extensive proceeds experiment; the results are reliable.
- However, due to the diversity of the practical application of application conditions are beyond our control, so users need to be tested before use to make sure the product is applicable.
- My company does not guarantee under certain conditions the use of our problem with the product, and is not liable for any direct, indirect or incidental damages.
- Users who encounter any problems during use can contact our technical service department, we will try to provide you with as much as possible to help.
Use these steps:
- Depending on the material surface treatment, surface dry and clean, no weak boundary layer;
- Interface adhesive bonding material on the need for continuous coating, be careful not to disperse;
- 3 Lights positioning the glue into the short ultraviolet curing lamp radiation, until the hand nudging fixed;
- To remove the excess glue with a knife to scrape the glue overflow, or a soft cloth, paper towel and gently erase the excess glue can also be dipped in acetone, alcohol wipe;
- Full cure time high radiation, until fully cured, note the temperature is not too high;
- Dipped in acetone, alcohol, cleaning materials with a soft cloth or paper towel and gently wipe the bonding good material.
Instructions for use:
- The adhesive surface is clean, dry and free of grease, you can wipe with acetone, hair dryer.
- The UV lamp positioned curing, the curing rate is dependent on the glue to absorb light energy from the light source associated with, the light transmittance material and other factors.
- The operation should not squeeze too hard to be sticky, and shall not be repeatedly moved apart adherend.
- Using the rest of the glue doesn't fall back to the original packaging to avoid contamination.
Note:
- Do not allow contact with children.
- Avoid contact with eyes, skin and clothing. This pair of eyes and a slight skin irritation.
- Rinse immediately with soap and water after skin contact. Please wash before they can wear the clothing.
- If accidentally splashed into the eyes, rinse immediately with plenty of water, as there does not need to go to hospital.
- The UV Glue is a special product and can only be shipped in a special way (post mail). Some countries and regions do not have shipping services for this product.
Storage:
This product is sensitive to light and heat, you need storage in a cool, dry place, away from light below 28 ° C, valid for one year.
Key performance indicators:
Appearance: pale transparent liquid
Viscosity cps: 550 ± 100 (Brookfield DV-II viscometer at 25 ° C, SC 4-15 rotor)
Hardness (Shore D): 53 (GB / T 531-1999 curing test)
Typical curing nature:
K-303 will be cured under ultraviolet light, the sun will slowly solidify. 220-260nm light source helps cure surfaces.
Cure rate, depth, and ultimately curing effect is dry and UV light source, exposure time, light transmittance related material. Suggested by experiments to determine the final curing process.
Positioning time:
6s-125W PHILIPS high-pressure fluorescent lamp, 4.5 mW / cm 2; UVA 3mm thick PMMA / PMMA.
Typical cured properties:
Tensile shear strength (GB 7124-86) overlapped area of 25 × 5 = 125mm2: PS / PS 4-5MPa destroys both PS 30 ° C.
